Filter
Top Products
4 C2910M-C-QS (4/06)
LENS
The CCC5100H Series camera supports both manual and DC-drive auto iris lenses,
either fixed focal length or varifocal. The camera accepts both CS- and C-mount lenses
without an adapter.
To mount the lens onto the camera:
1. Use clean, compressed air to remove any dust or other foreign matter between
the lens and the camera imager.
2. Screw the lens onto the lens mount.
3.
DC-drive auto iris lens:
Connect the four-pin connector from the lens to the
connector on the back of the camera.
NOTE:
Before using a DC-drive auto iris lens, you must adjust the DC offset setting
(refer to
DC-Drive Auto Iris Lens Setup
).
MOUNT
The CCC5100H Series camera can be mounted from either the top or bottom. Use a
mount or enclosure that includes a standard 1/4-20 screw with a maximum thread
length of 0.375 inches (10 mm). If using the Pelco PCM150 camera mount, refer to the
PCM150 Installation manual.