Filter
Top Products
[ 12 ] Pelco Manual C2915M-E (08/05)
RJ45-10 Connections
The RJ45-10 connector allows video (composite and twisted pair) and power connections to be made to the
camera using a single Cat5-style cable.
NOTE: The PCM150 camera mount is designed for the CC3770 Series camera. It comes with preconfigured
auxiliary connectors and cables as well as an easy-to-wire adapter plate.
Before installation, identify the RJ45-10 connector leads to be used. To create the connection you will need a
Cat5 cable with the appropriate number of pairs and an 8-way or 10-way RJ45-10 connector. You will also need
a crimping tool capable of cutting, stripping, and crimping RJ50 (10P10C) connectors.
Wire the cable and connectors according to Table D. (More information about wiring each pair of leads appears
in the text below the table.) Then plug the auxiliary connector into the camera.
Figure 5. RJ45-10 Connector
Table D. RJ45-10 Pinouts
* CC3770H-6 and CC3770H-6X models only
Composite Video Out
Pins 2 and 3 provide a composite video output signal.
NOTE: The RJ45-10 composite video out is only intended to be used to route the video signal to a break-out
box where a conventional coaxial connection will be made.
8-WAY 10-WAY
- 1 No connection
1 2 Composite video ground
2 3 Composite video
3 4 Manual color/b-w switch
4 5 Twisted pair video output (-)
5 6 Twisted pair video output (+)
6 7 Manual color/b-w switch
7 8 24 VAC *; 12 VDC (-)*
8 9 24 VAC *; 12 VDC (+)*
- 10 No connection
PINS
FUNCTION
The following instructions apply to 10-way connectors. When using an 8-way connector, refer to tables C and D.