Filter
Top Products
6 C2485M-A (1/05)
Site Installation
1
Feed a fiber optic cable (not supplied) and the supplied wiring harness into
the front of the mount and out the back of the mount. Connect the wires
as required. Refer to Tables A, B, and C for cable and wiring information.
Fasten the mount to the mounting surface. Refer to the instructions sup-
plied with the mount.
2
Remove the back box mounting plate: Loosen the nuts on top of the back
box until they reach the locking material at the end of the studs, and then
turn the mounting plate clockwise and lift.
3
Thread the wiring from the mount through the mounting plate, and
then attach the mounting plate to the mount. If outdoors, apply thread
compound (provided) to the threads on the mounting plate.
4
Attach the connector of the wire harness to the mating connector located
on the top of the back box. Connect the fiber optic cable. Insert the studs
and nuts on top of the back box into the mounting plate, turn the back box
counterclockwise, and then tighten the three nuts.