Filter
Top Products
9
Introduction and Installation
Installing the door station
Make sure to install the door station on a flat, vertical wall.
Important information:
On the bottom surface of the door station, there is a hole to allow water to drain. Do not
cover it up when installing.
1 Unscrew the hex-head screw using the longer end of the allen wrench and remove the
mounting bracket from the rear of the door station.
LThe pin hole camera is not a screw to be touched or removed.
Hex-head screw
(Attached to the door station)
Allen wrench
Mounting bracket
Pin hole camera
VL-GC001A.book Page 9 Monday, February 28, 2005 12:08 PM