Filter
Top Products
5
C-1 Pull out the power cord and put the plug into the socket outlet.
C-2 ON/OFF switch button (N)
To start or stop the cleaner, press the button.
Switch knob button (L)
To increase or reduce the power, turn the button. (Only MC-CL483K)
C-3 Switching between carpet or flooring
Flooring : Press lever A
Carpet : Press lever B
C-4
The curved wand is attached with manual suction regulator,
which allow you to briefly reduce the suction power.
C-5 Cord rewind button (M)
After you finish vacuuming, remove the plug from the wall socket and press the button to rewind back the power cord.
When rewinding the power cord, always hold the
plug so that it does not become damaged or stricking you.
NOTE:
In case it is impossible to rewind the power cord, pull out the power cord and press the button again.
C-6 Storage position
Insert the nozzle holder straight in the nozzle supporter on the under side of the main body.
C-7 Park position
For short breaks during vacuuming, insert the nozzle holder straight to the nozzle supporter on the rear side of
the main body.
NOTE:
When you use park position, please turn off the power first to prevent from heating up.
IMPORTANT:
To obtain the good performance of the vacuum cleaner, we encourage you to rotate the filter knob (P) for two complete cycles each time after finish vacuuming.
C - HOW TO OPERATE YOUR CLEANER / /
C-.
C-
/)N(
.
)L(
) .MC-CL K(
C-
:A
:B
C-
.
C-
)M(
.
.
:
.
C-
.
C-
.
:
.
:
)P (.
C-
.
C-
/(N)
.
(L)
)MC-CL K(
C-
:A
:B
C-.
C-
(M )
.
.
:
.
C-
.
C-
.
:
.
:
(P)
.