Filter
Top Products
12
3
Attaching the control panel stand to the right or left side panel of the unit
(Diagram shows attachment to right armrest.)
The position of the control panel when seated can be
selected by choosing the appropriate hole for the screw.
Near
Approx.
20˚
Far
4
Attaching the control panel stand covers
(On both the right and left sides)
The method for attaching the covers is the same for both sides.
The diagram shows the side where the control panel stand is
attached.
1. Insert the top tabs on the cover into the bottom
notches on the armrest.
2. Insert the bottom tabs into the notches on the
armrest.
1. Insert the attachment screw into the lower hole first
and then tighten lightly by hand.
2. Securing the stand with the attachment screws.
Tighten the two screws for the remaining two holes
lightly by hand and then tighten firmly with the allen key.
2
Control panel stand
1 Insert the attachment
screw in either hole and
then tighten.
Attachment screw
Allen key
Use this screw
Attachment Screw (M6 × 16)
× 3
(Silver × 3)
Cover for Side WITH
Control Panel Stand
Cover for Side WITHOUT
Control Panel Stand
Notches
Top tabs
Control panel
stand cover
Notches
Bottom tabs
Push the cover until
you hear it click.
Control panel
stand
Allen key
Allen key
Control panel stand
Attachment
screw
Attachment screw
Hole
Hole
To attach the control panel stand using the attachment
screws, tighten the screws level with the holes as
shown in the figure below.
If the screws are tightened at an angle, the hole may
become deformed and the screws may become stuck in
the middle.
Tighten the screws
level with the holes.
Do not tighten the
screw at an angle
with the hole.
EP30004.indb 12 2007/07/19 13:07:38