Panasonic CZ-64ESMC1U Thermostat User Manual


 
3
EN
INSTALLATION LOCATION
We recommend that this system controller be installed properly by qualifi ed
installation technicians in accordance with the Installation Instructions provided
with the system controller.
WARNING
Do not install this system controller where there are fumes or fl ammable gases,
or in an extremely humid space such as a greenhouse.
Do not install the system controller where excessively high heatgenerating
objects are placed.
ELECTRICAL REQUIREMENTS
All wiring must conform to the local electrical codes. Consult your dealer or a qualifi ed 1.
electrician for details.
Wiring must be done by a qualifi ed electrician.2.
CAUTION
To warm up the system, the power mains must be turned on at least fi ve (5) hours
before operation. Leave the power mains ON unless you will not be using this
appliance for an extended period.
SAFETY INSTRUCTIONS
Read this Operating Instructions carefully before using this system controller. If you
still have any diffi culties or problems, consult your dealer for help.
The air conditioner is designed to give you comfortable room conditions. Use this only
for its intended purpose as described in the Operating Instructions.
WARNING
Never touch the unit with wet hands.
Never use or store gasoline or other fl ammable vapor or liquid near the air
conditioner — it is very dangerous.
The air conditioner has no ventilator for intaking fresh air from outdoors. You must
open doors or windows frequently when you use gas or oil heating appliances in the
same room, which consume a lot of oxygen from the air. Otherwise there is a risk of
suffocation in an extreme case.
CAUTION
Do not turn the air conditioner on and off from the power mains switch. Use the ON/
OFF operation button.
Do not stick anything into the air outlet of the outdoor unit. This is dangerous
because the fan is rotating at high speed.
Do not let children play with the air conditioner.
Do not cool or heat the room too much if babies or invalids are present.
Note:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, follow the attached installation instructions.
Any changes or modifi cations not expressly approved by the party responsible for compliance could void
the user’s authority to operate this equipment.