Panasonic CW-XC85HU Air Conditioner User Manual


 
6
About the Controls on the Air Conditioner
OPERATION
TEMP
TIMER
AIR
SWING
MODE
ECONOMY
FAN SPEED
1
3
2 4
6
5
7
OPERATION
TEMP
TIMER
MODE
ECONOMY
FAN SPEED
1
3
2 4
6
5
Model: CW-XC85HU Model: CW-XC65HU
Remote controller
OPERATION
To turn the air conditioner ON, push the button.
To turn the air conditioner OFF, push the button
again.
This button takes priority over any other buttons.
When you first turn it on, the air conditioner is on
the High cool mode and the temp. at 72°F (22˚C).
MODE
Every time you push this button,it will toggle
between COOL, ECONOMY, FAN and DRY.
ON/OFF TIMER
- STOPPING OPERATION
Every time you push this button, when the air
conditioner is operating, timer is set as follows.
(1Hour 2Hours 3Hours 4Hours 5Hours
6Hours 7Hours 8Hours 9Hours
10Hours 11Hours 12Hours O)
The Setting Temperature will be raised by
2°F (1°C) 30 min. later and by 2°F (1°C) after
another 30 min.
- STARTING OPERATION
Every time you push this button, when the air
conditioner is not operating, timer is set as follows.
(1Hour 2Hours 3Hours 4Hours 5Hours
6Hours 7Hours 8Hours 9Hours
10Hours 11Hours 12Hours O)
FAN SPEED
Every time you push this button it is set as follows.
{High(F3) Low(F1) Med(F2) High(F3)...}.
TEMPERATURE SETTING
This button can automatically control the
temperature of the room.
The temperature can be set within a range of 60°F
to 86°F by 2°F.(16˚C to 30˚C by 1˚C) Select the
lower number for lower temperature of the room.
ECONOMY
If the switch is set to "On", the fan stops when the
compressor stops cooling. Approximately every 3
minutes the fan will turn on and check the room air
to determine if cooling is needed.
AIR SWING
This button can automatically control the air flow
direction.
DRY
When this unit is in dry mode, the fan rotates in
low speed. The fan stops when the compressor
stops cooling.
Approximately every 3 minutes the fan will turn on
and the unit checks the room air temperature to
set itself.
Precaution:
The Remote Controller will not function properly if strong light strikes the sensor window of the
air conditioner or if there are obstacles between the Remote Controller and the air conditioner.