Panasonic CS-A12CTP Air Conditioner User Manual


 
Pre-season Inspection
Clean the air filters, re-insert and operate the air
conditioners.
Is the discharged air cold / warm?
Operation is normal if 15 minutes after the start of
operation, the difference between the air intake and
outlet vents temperature is:-
Are the air intake or outlet vents of the indoor or
outdoor units obstructed?
Are the remote control batteries weak?
If the remote control display appears weak, replace
the batteries.
When the Air Conditioner is Not Used
for an Extended Period of Time
1
To dry the internal parts of the indoor unit, operate
the unit for 2 - 3 hours using:-
2
Turn off the power supply and unplug.
3
Remove the remote control batteries.
Recommended Inspection
After used over several seasons, the unit will become
dirty and thus decreases the units performance.
Depending on the operation conditions, a dirty unit
may produce odour and dust may pollute
dehumidification system. Therefore, a seasonal
inspection is recommended in addition to regular
cleaning. (Consult an authorized dealer).
Cooling Model
FAN operation
Heat Pump Model
COOL operation with
30°C set temperature
Cooling Model
COOL > 8°C or above
Heat Pump Model
COOL > 8°C or above
HEAT > 14°C or above
HELPFUL INFORMATION
Auto Operation
Automatic Operation
If the remote control fails to function or has been
misplaced, press the Auto Operation button to start
the Automatic operation.
The Automatic operation will be activated
immediately once the Auto operation button is
pressed. However, temperature cannot be adjusted
in this operation.
The power indicator on the indoor unit will blink until
the operation mode is selected automatically.
To cancel this operation, press once more.
Timer Setting
When power failure occurs, the timer setting will be
cancelled. Once power is resumed, reset the timer.
Thunder and Lightning
This air conditioner is equipped with a built-in surge
protective device. However, in order to further
protect your air conditioner from being damaged by
abnormally strong lightning activity, you may switch
off the main power supply and unplug from power
socket.
Auto Restart Control
If power is resumed after a power failure, the
operation will restart automatically after 3 - 4
minutes.
Operation will be restarted automatically under the
previous operation mode and airflow direction when
power is resumed as the operation is not stopped
by the remote control.
ENERGY SAVING AND OPERATION
HINTS
Setting the Temperature
Approximately 10% of electricity can be saved.
Set the temperature higher or lower than the
desired temperature.
Cooling Model
Cooling Operation : 1°C higher
Heat Pump Model
Cooling Operation : 1°C higher
Heating Operation : 2°C lower
Air Filters
Clean the air filters every 2 weeks.
Dirty filters may reduces cooling or heating
efficiency.
Keep All Doors and Windows Closed
Otherwise, cooling or heating performance will be
reduced and electricity cost is wasted.
Outdoor Unit
Do not block the air outlet vents. Otherwise, it will
lower the cooling or heating performance.
Timer and Sleep Mode
To prevent wastage of electricity, use sleep mode
when sleeping or Timer when going out.
Avoid Direct Sunlight
Keep curtains or drapes closed to avoid direct
sunlight during cooling operation.
Press the Auto
Operation Button
AUTO OFF/ON
Call the Dealer Immediately
If the following conditions occur, turn off and unplug the
main power supply, and then call the dealer immediately.
Abnormal noise is heard during operation.
Water or foreign material gets into the remote
control by mistake.
Water leak from the indoor unit.
Switches or buttons do not operate properly.
The circuit breaker switches off frequently.
Power supply cord and plug become unusually
warm.
TROUBLESHOOTING
Normal Operation
Is it okay?
Air conditioner has been restarted, but does not
operate for 3 minutes.
A sound like water flowing can be heard.
It seems that fog is coming out from the air
conditioner.
The room has a peculiar odour.
The outdoor unit emits water or steam.
During Automatic Airflow Volume setting,
indoor fan stops occasionally.
(For Heat Pump Model only)
Operation stops for about 12 minutes during
heating (The power indicator blinks).
(For Heat Pump Model only)
During heating operation, indoor fan may
run at on and off conditions.
Abnormal Operation
Is it okay?
The air conditioner does not operate.
Air conditioner produces loud noise during
operation.
The air conditioner does not cool or warm
effectively.
Remote control / display doesnt work
This is the answer
This is to protect the air conditioner. Wait until the air
conditioner begins to operate.
This is the sound of refrigerant flowing inside the air
conditioner.
Condensation occurs when the airflow from the air
conditioner cools the room.
This may be a damp smell emitted by the wall,
carpet, furniture or clothing in the room.
In COOL/DRY operation, moisture in the air
condenses into water on the cool surface of outdoor
unit piping that causes dripping.
This is to remove the smell emitted by the
surroundings.
This is to melt the frost which has accumulated on
the outdoor unit (defrosting operating). This will take
no longer than about 12 minutes. Water drips from
the outdoor unit. Wait until this operation ends.
(the power indicator will light up). (Frost will
accumulates on the outdoor unit when the outdoor
temperature is low and humidity is high.)
This is to prevent undesired cooling effect during
heating operation.
Please check
Has the circuit breaker been tripped?
Has the power plug been removed from the wall
outlet?
Is the timer being used correctly?
Is the installation work slanted?
Has the temperature been set incorrectly?
Are the filters dirty?
Are the intake or outlet vents of the outdoor unit
obstructed?
Are all windows and doors closed?
Batteries empty?
Batteries correctly inserted (+) and ()?
38
CS-A12CTP CU-A12CTP5 / CS-A18CTP CU-A18CTP5 / CS-A24CTP CU-A24CTP5