Filter
Top Products
7
ENGLISH
SPECIAL
NORMAL
WARNING: Unplug cord from electrical outlet before servicing.
Remove lamp housing by removing two (2) screws in the top of the lamp housing. Pull burned out bulb from holder
and replace with new bulb. Replace lamp housing by replacing two screws in the top of the lamp housing.
Replacing Light Bulb
WARNING: Unplug cord from electrical outlet before servicing.
Turn the power head over. With baseplate facing up, remove the screw located in the center of each edge brush.
Remove both edge brushes and replace with new ones. Replace both screws and tighten.
Replacing Edge Brush
Your ORECK XL21 vacuum cleaner has a special ORECK FRESH AIR
®
tab pocket.
This light-colored pocket is located inside the outer cloth bag in the area where the
paper filter dust bag attaches to the intake tube. Insert tablet in pocket if desired.
Using an Oreck Fresh Air
®
Tab
WARNING: Unplug cord from electrical outlet before servicing.
The Motor Filter located at the back of the power head should be replaced every 2 months.
The Scent Disk should be replaced every month when changing the inner filter bag.
Press two locking tabs on scent cartridge cover and remove the cover.
Remove the cartridge holder by lifting on tab at top of holder.
Remove old filter or scent disk from holder. Replace filter or scent disk and reinsert holder.
Replace door by aligning tabs on door with slots in housing and pressing the door in place until tabs lock.
Replacing Motor Filter and Oreck Fresh Air
®
Scent Cartridge
18
19
20
21
22
23
24
23
22 23
24