Filter
Top Products
13
efficient way to clean the rest of the area. Allow plenty of time for the heat to
penetrate the surface. This is especially helpful in the shower area if there is tile or
grout.
Removal of soap scum on tile, grout, and shower doors is also easier with the
Vapor Cleaner.
To clean the toilet, use Small Detail Brush. Use a terry cloth towel or paper towel to
wipe up excess moisture and residue.
To clean the sink and faucets, use Small Detail Brush.
Exterior Areas: To clean inside your car, use the Rectangular Floor/Carpet Brush
with a Terry Cloth Towel attached to clean upholstery and interior areas just as in
the home. You should not expose the bristles to leather - use only the brush with
the terry cloth towel attached. For detailing the wheels, use the Concentrator
Nozzle and the Small Detail Brush. Outer windows are cleaned best by applying
the vapor with the Small Detail Brush and following with a paper towel. To clean
bicycles, use the Small Detail Brush. To clean equipment, use the Small Detail
Brush, depending on the surface area.
Artificial Plants: Use the Concentrator Nozzle without a brush attached to blow off
the dust and dirt.
Clothing: Your vapor cleaning system is excellent for removing wrinkles from
fabrics. Simply “vaporize” the surface from a distance (12in - 18in). The dry vapor
removes wrinkles without leaving the fabric wet like ordinary fabric steamers will.
Nicotine and Tar: Nicotine and tar dissolve at high temperatures and become a
light yellow oil. When the nicotine/tar film is touched by a hot terry cloth towel
clipped over the Rectangular Floor/Carpet Brush, it immediately dissolves and flows
into the towel. You can remove it from flat surfaces as fast as you can move the
brush over the surface.
Removing Wax, Tar, Gum, Etc.: Many
stains are only stuck on the surface of
materials and can be easily and quickly
removed by “blowing” excess material
away from the surface from the side.
This is accomplished by using the
Concentrator Nozzle. Hold the Terry
Cloth
T
owel to the side to catch the
loose residue as it is blown by the
Concentrator Nozzle. Note: Always
vacuum any loose residue off the
surface before you apply vapor to it.