Filter
Top Products
18
Replace Brushroll Cover
• Place brushroll cover back over the brushroll.
• Replace the two cover screws.
Replace Nozzle Hood
• The wand must be in the upright locked position.
• Position the hood on top of nozzle base. Make sure wires
and buttons are aligned. Do not force the hood on.
• Turn the nozzle over.
• Replace the seven screws for the hood. See Step 1.
When to Replace the Brushroll
• When brushroll bristles are worn, the brushroll should
be replaced.
• To check condition of the bristles, hold a card on the
bottom plate while turning the brushroll. Replace the
brushroll if bristles do not touch the card.
Step 8
Step 9
ALWAYS DISCONNECT
VACUUM FROM
ELECTRICAL OUTLET
BEFORE STARTING
THIS PROCEDURE!
Maintenance
- continued