Filter
Top Products
MOUNTING THE WALL SLEEVE
FOR WOOD CONSTRUCTION
Refer to Figure 2.
Mount the wall sleeve so the flange of the outside panel
is flush against the outside sheathing and held in place
by nails through the pre-drilled holes of the flange.
FOR BRICK CONSTRUCTION
Refer to Figure 3.
Mount the wall sleeve against face of brick and grout
into place.
INSTALLING THE INSIDE SLEEVE
Refer to Figure 4.
1. Insert the inside sleeve into the wall cavity. Align the slots
of the inside sleeve with the pre-drilled holes of the wall
sleeve and secure together with screws supplied.
INSTALLING THE OUTLET BOX
Refer to Figure 5.
1. Remove knockout from the outlet box and mount the box
inside the housing.
2. Make connections; be certain the unit and switches are
properly grounded and all wiring complies with electrical
code requirements.
3. Using screws supplied, install the outlet box cover.
COMPLETING THE INSTALLATION
Refer to Figure 6.
1. Install Motor/Blade Assembly being certain the motor lead
is towards the receptacle on outlet box cover.
2. Plug motor lead into receptacle.
3. Fasten the grille in place with thumbscrew supplied.
MAINTENANCE AND CLEANING
•
Disconnect the power before servicing or cleaning the fan.
•
If the fan grille or fan blades become soiled, clean them
with a mild soap and water solution.
FIGURE 4
FIGURE 5
FIGURE 6
INSIDE SLEEVE
SECURE INSIDE
SLEEVE TO
WALL SLEEVE
OUTLET BOX
KNOCKOUTS
OUTLET BOX
COVER
PLUG MOTOR
LEAD INTO
RECEPTACLE
FIGURE 3
FIGURE 2