Filter
Top Products
FIGURE 2
FIGURE 3
FIGURE 4
AIR FLOW
CONTROL KNOB
GRILLE
EXTENSION
BRACKET
GRILLE
BLACK
GREEN
SWITCH
BOX
120vAC
HOUSE WIRE
WHITE
SOCKET
BOX COVER
BOX
CONNECTOR
OUTER SLEEVE
AIR FLOW
ON/OFF SWITCH
WIRING
1. Run 120vAC housing wire to fan location.
2. Refer to figure 3. Remove two (2) screws in switch box
and carefully pull off box cover.
3. Remove one of the circular knockouts in the bottom
of switch box.
4. Pull supply wires through knockout hole.
5. Connect supply wires to fan wires as follows: black
to black; white to white; green to green grounding screw.
6. Replace switch box cover and secure with two (2) screws.
COMPLETING ASSEMBLY
1. Remount motor and fan assembly; secure by tightening
screws into small end of keyhole slots. Plug the fan motor
wire into two-prong socket in the switch box.
2. Mount grilles and secure with two (2) screws.
3. Place control knob onto switch shaft.