Filter
Top Products
10
6. Thoroughly dry all washed parts.
4. Clean the Plasma Dust Filter
Use a soft scouring pad or toothbrush to
clean the dust collector.
Use warm water (below 40° C) only!
Please take care not to damage any wiring while cleaning the dust collector
If any electrical discharge wire is broken, the device will lose part or
all of its dust collecting capability.
Any broken wire should be thrown away instead of being left inside the unit.
Otherwise, a dangerous short-circuit or high-voltage sparks may occur.
Please contact info@realspiritusa.com for additional electrical discharge wire.
Please do not clean using acidic or alkaline detergent that can create rust on the surface of device.
The Cleaning and Maintenance of the Washable Plasma Dust Filter (Cont.)
CLEANING AND MAINTENANCE
(
CONT.
)
Use mild detergent or plain water only.
5. If dust and dirt does not wash away easily, pre-soak with diluted
detergent and then use a toothbrush to scrub.
Plastic Wrap
After cleaning, please completely dry the unit before use.
Operating a wet unit may cause electrical shock or malfunction.
If the front cover of the plasma dust collector is not properly installed,
the unit will not function.
Please make sure the plastic wrap for the electrical discharge wire
is located in its proper position.
Advanced PureAir Newport 9000 Owner’s Manual
TM