Filter
Top Products
17
3. Remove the top most brass brake distribution block and bracket.
Fig 1.2
4. Loosely install the new brake/clutch distribution block and loosely
reinstall all brake lines.
3. Install clutch line (part number 30851-1W200) across the firewall. It
is easiest to feed this line down on the passenger side and into the
new distribution block (fig 1.2).
4. Loosely thread the line into the distribution block and then secure
it along the firewall and threat it into the clutch dampener.
5. Once you have the distribution block and the firewall clutch line
installed you may tighten all lines and brackets.
Clutch Installation
Warning: Do not allow grease to contaminate the clutch surface.
1. Remove the drive plate by having a helper keep the crankshaft
from turning while you remove the drive plate bolts.
2. Inspect the crankshaft mounting surface and make sure no debris
are in the thread holes.
3. Remove the pilot adapter for the automatic transmission using the
blind hole puller. The blind hole puller is available at auto part
stores.
Fig. 3.4 Blind hole puller tool.
4. Install the new pilot bushing into the crankshaft.