Filter
Top Products
9
W415-0559 / 02.15.06
3. Place the hole in the underside of log #3 onto the locating
screw, on the right side of the burner. The bottom branch of
log #3 sits infront of, and against, the right end of log #2.
4. Reinstall the screen & front.
LOG AND LOGO PLACEMENT
In order to assemble the log set, the screen and cast front
must be removed, see Cast Front / Screen Removal in the
Finishing section of this manual.
1. Place the rear log, as shown, onto the rear log support
brackets. Bend the bracket on the right side to help retain
the rear log against the back of the fi rebox.
2. Place the hole in the underside of log #2 onto the locating
screw, on the left side of the burner. The fi bre burner is formed
to cradle the centre of the log.
LOG PLACEMENT
Remove the backing of the logo supplied and centre over the
logo installation holes, as indicated.
LOGO
LOGO PLACEMENT