Filter
Top Products
22
W415-0607 / A / 01.18.08
90°
FINISHING
GLASS DOOR INSTALLATION AND REMOVAL
1. Lift the top cast piece off of the unit.
2. Pull handle forward and rotate 90º to unlatch the door.
Figure 41a.
3. Lift door straight up to remove. Figure 41b.
FIGURE41a
LOGO PLACEMENT
LOGO
1/2”
1/2”
Remove the backing from the logo and position onto the
control door as shown.
FIGURE 42
DOOR
FIGURE41b
1. Place the door frame face down careful not to scratch the
paint.
2. Center the gasketed glass inside the door frame with the
thick side of the gasket facing up.
3. Bend the glass retainers located along the edge of the door
frame over the gasket holding the glass in place. Careful not
to break the glass.
DOOR GLASS REPLACEMENT
NOTE: Care must be taken when removing and disposing of any broken glass or damaged components. Be sure
to vacuum up any broken glass from inside the stove before operation.
GLASS
GASKET
DOOR
FRAME
GLASS
RETAINERS
FIGURE43