Filter
Top Products
W415-0760 / 12.19.08
16
5.1.1 Plug in your electric appliance.
5.1.2 Make sure the appliance's main Power ON/OFF button is at the ON position!
The remote control will NOT work if the main Power button is at the OFF
position.
5.1.3 When operating the remote control, it must be directed towards the front
of the appliance.
5.1.4 The button at the top left corner of the remote is the main ON/OFF
power button. Pressing this button activates the power to the appliance.
5.1.5 To adjust the ember bed brightness, press the “+” or “-” buttons. To
increase the ember bed brightness, press the “+” button, to decrease
the ember bed brightness, press the "-" button. There are seven levels
of brightness.
5.1.6 To activate the appliance, press the button. Press and release the
button to cycle through LO, MED, HI and OFF. Each time the button
is pushed, the Appliance LED will change to its corresponding colour:
Green for LO, Orange for MED, Red for HI, and blank for OFF. The
appliance has a built-in thermostat so it will shut off automatically once the
pre-set temperature is reached. It will also turn on automatically if the room
temperature drops below the pre-set temperature.
5.1.6 To adjust the height of the ame, press the “+” or “-” buttons. To increase the height of the ame, press
the “+” button, to decrease the height of the ame, press the "-" button. There are seven levels of
ame effects.
5.1.7 To turn off the appliance, press the ON/OFF button once.
NOTE: This remote control must remain within 8 meters or 26 feet of the appliance to be effective.
Make sure your batteries are fully charged and installed correctly in your remote control.
REMOTE CONTROL FOR ELECTRIC
FIREPLACE
Indicator
Light
Infrared Ray Exit
ON/OFF
-
+
+
-
FIGURE 5.1
5.1 remote control