Filter
Top Products
12
W415-0320 / D / 01.06.07
FIGURE 20
DRYWALL
DRYWALL
Combustible materials may be installed flush with the front
of the fireplace but must not cover any of the black face-
areas of the fireplace. Non-combustible material (brick,
stone or ceramic tile) may protrude in these areas.
It is not necessary to install a hearth extension with this
fireplace system.
When roughing in the fireplace, raise the fireplace to ac-
commodate for the thickness of the finished floor materi-
als, i.e. tile, carpeting, hard wood, which if not planned for
will interfere with the opening of the lower access door and
the installation of many decorative flashing accessories.
Objects placed in front of the fireplace should be
kept a minimum of 48" away from the glass front
faces.
Refer to pages 14-17 for complete instructions regarding
mantle requirements and installations, log placement,
glass door and upper and lower louvre attachments.
It is best to frame your fireplace after it is positioned. Use
2x4's and frame to local building codes. FIGURE 18.
To install the fireplace face flush with the finished wall,
position the framework to accommodate the thickness
of the finished wall.
FIGURE 18
A = 22
1
/8 " minus finishing material thickness each side.
B = 36 " minus finishing material thickness each end.
Install the base panels as illustrated in steps 1-4 on page
9.
FIGURE 19
ISLAND INSTALLATION PROCEDURE
BRICK PANEL INSTALLATIONFRAMING
FACING
FINISHING