Filter
Top Products
uslrBgyourcdetoaml
addiurmtheqs8mm
If
your system includes the
Once you enter your personal
Napco Digit-Key keypad you can
code into the Napco Digit-Key
choose your own private code
keypad, the red ARMED/MEMORY
to arm and disarm the Control
light will go on to show the Control
Center. To program your code,
Center is armed, and off to show
slide the switch (upper left hand
it is disarmed. If you enter the
corner of your Control Center)
wrong code, your alarm system will
into the LOAD position. Go to the
fail to respond. Be sure to WAIT
Digit-Key keypad and enter any
5 SECONDS before attempting to
combination of numbers up to 6
re-enter your code.
digits (there is no zero). Use a
number you will remember such
as your birthday (12-s-47) rather
Chmg@lyMlrm
than something obvious like your
Slide the switch into the LOAD
address. The
nUmberSYOU
choose
position. Enter
a
new
c&e
into
become the only code
“recog-
the Digit-Key keypad. Return the
nized”
by your system. Return
to the Control Center and slide
switch to the RUN position.*
the switch to the RUN position.*
REMINDER: When arming or
dis-
YOUR
SECURITY
SYSTEM
WILL
respond, you may have entered
arming, if the red light does not
NOT OPERATE IN THE LOAD
the wrong code. Wait 5 seconds
POSITION.
before trying to enter your code
again.
‘When entering your
personal code for the first time, or reentering your code
after an extensive power failure, enter the code again
after moving the switch to
6
the RUN position. This will activate the keypad lights and arm the system.