Multiquip P200DLST Heat Pump User Manual


 
DRY PRIME PUMP — OPERATION AND PARTS MANUAL — REV. #3 (10/06/08) — PAGE 11
Maintenance Safety
NEVER lubricate components or attempt service on a running
machine.
ALWAYS allow the machine a proper amount of time to cool
before servicing.
Keep the machinery in proper running condition.
Fix damage to the machine immediately and always replace
broken parts.
Dispose of hazardous waste properly. Examples of potentially
hazardous waste are used motor oil, fuel and fuel filters.
DO NOT use food or plastic containers to dispose of
hazardous waste.
DO NOT pour waste, oil or fuel directly onto the ground,
down a drain or into any water source.
RULES FOR SAFE OPERATION
NEVER pump volatile, flammable or low flash point fluids.
These fluids could ignite or explode.
NEVER pump corrosive chemicals or water containing toxic
substances. These fluids could create serious health and
environmental hazards. Contact local authorities for
assistance.
NEVER open the volute cover during operation or start the
pump with the cover off. The rotating impeller inside the pump
can cut or sever objects caught in it.
NEVER block or restrict flow from discharge hose. Remove
kinks from discharge line before starting pump. Operation
with a blocked discharge line can cause water inside pump to
overheat.
NEVER run engine without air cleaner. Severe engine damage
may occur.
ALWAYS read, understand, and follow procedures in
Operator’s Manual before attempting to operate equipment.
ALWAYS be sure the operator is familiar with proper safety
precautions and operations techniques before using pump.
ALWAYS store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of the
reach of children.
Refer to the
Engine Owner's Manual
for engine technical
questions or information.
In winter, drain water from pump housing to prevent freezing.
ALWAYS make sure pump is correctly secured to the trailer.
Check all supports attaching the pump to the trailer and make
sure they are tight.
ALWAYS make sure that the pump's trailer is placed on solid
level ground so that it cannot slide or shift around, endangering
workers. Deploy jack stands for stabilization. Place blocks
under the trailer's bumper to make it level (prevents tipping),
and use a chocked block underneath the wheels to prevent
rolling. Also keep the immediate area free of bystanders.
High Temperatures – Allow the engine to cool before adding
fuel or performing service and maintenance functions. Contact
with
hot
components can cause serious burns.
Add 1000 lbs. (454 kg.) to the
operating weight for a full tank of
fuel, 140 gallons (530 liters).
NOTE
In emergencies
always
know the location of the
nearest phone or
keep a phone on the job site
.
Also know the phone numbers of the nearest
ambulance
,
doctor
and
fire department
. This
information will be invaluable in the case of an
emergency.
Lifting
The pump has an operating weight of 3180 lbs. (1,442 kg) or
more . Use lifting equipment with a rated capacity of at least
14,000 lbs. (6,350 kg). Remove suction & discharge hoses/
pipes before lifting.
EMERGENCIES
ALWAYS know the location of the nearest
fire
extinguisher
and first aid kit.