Filter
Top Products
PAGE 18 — MQ-MIKASA MVH-304GHB PLATE COMPACTOR — PARTS & OPERATION MANUAL — REV. #0 (11/25/02)
MVH-304GHB — OPERATION
6. Grasp the starter grip (Figure 14) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.
7. If the engine has started, slowly return the choke lever
(Figure 15 ) to the
CLOSED
position. If the engine has not
started repeat steps 1 through 6.
Figure 14. Starter Grip
8. Before the compactor is placed into operation, run the engine
for several minutes. Check for fuel leaks, and noises that
would be associated with a loose component.
Figure 15. Choke Lever (Closed)
TRAVELING
Make sure to follow all safety rules referenced in
the safety section of this manual before operating
compactor. Keep work area clear of debris and
other objects that could cause damage to the
compactor or bodily injury.
CAUTION :
Figure 17. Travel Lever
Figure 16. Throttle Lever ((Fast)
5. Place the
engine ON/OFF switch
(Figure 13) in the "
ON
"
position.
Figure 13. Engine ON/OFF Switch (ON Position)
1. Grasp the compactor's hand grip (Figure 16), and move the
throttle lever (Figure 16) quickly to the
fast
position.
2. With the throttle lever in the fast position, the engine speed
should be around 2,300 RPM, therefore engaging the cen-
trifugal clutch
NOTE
ALWAYS move the throttle lever
quickly without hesitation, because
increasing the engine speed slowly
causes the clutch to slip.
3. To make the compactor move in the forward direction push
the travel lever ( Figure 17) forward