Filter
Top Products
7
7
Using in upright steam cleaning mode (continued)
5
Select the desired steam level by pressing the
steam level select button (12) until the indicator
light next to your desired level is illuminated:
low steam (19), for use on laminates and wood.
medium steam (18), for use on vinyls or carpets.
high steam (17), for use on ceramics.
Steam will start to be emitted around 30 seconds
after the steam level select button is pressed.
7
Place the floorhead (22) on the floor. Hold the
floorhead to the floor with your foot and tilt the
steam cleaner back.
Never hold the steam cleaner continuously in
one place, as excess moisture and heat may
adversely affect some floor surfaces.
6
If cleaning carpets, rest the floorhead (22) with
the micro-fibre floor cloth (27) attached into the
carpet glider (31) to make it easier to move the
floorhead across the carpet.
NOTE: The carpet glider is designed to make it
easier to move the floorhead across the carpet
and is intentionally a loose fit on the floorhead.
8
If attempting to steam clean a heavily soiled
area on either carpet or hard floor, it may be
necessary to operate the vibrate function. This
will vibrate the floorhead (22) to help agitate the
dust and dirt. To use this function, press the
vibrate button (14). To stop the vibrate function,
press the vibrate button again.
9
To enable you to more easily see the areas in need
of cleaning, you may use the LED lights (25) situated
in the front of the floorhead (22). Press LED light
button 1 (13) to illuminate the area, and press LED
light button 2 (16) if additional illumination is
required.
VC720506MUK Rev1_Instruction Book 09/01/2014 16:42 Page 7