Filter
Top Products
After use
1 Switch the cleaner off and unplug from
the socket. Wait until the cleaner has
cooled down completely.
2 Release any steam pressure by pressing
the steam trigger on the handle
3 Apply the steam safety lock.
4 Remove the filler cap.
5 Empty the water tank. Allow the inside of
the water tank to dry out before
replacing filler cap.
Rinse water tank
To clean the water tank fill it with clean
water and shake vigorously. This will
release any limescale deposits that have
collected on the bottom of the tank. Pour
the water out by holding upside down.
Descaling
In order to prolong the life of your
cleaner you should descale the steam tank
at least every 6 months.
1 Switch the cleaner off, unplug and allow
to cool.
2 Empty any water out of the tank.
3 Mix the descaler in the measuring jug
using warm water. We recommend using
50gm of citric acid crystals per 1 litre of
water. Citric acid crystals are available
from most pharmacies.
4 Pour 1 litre of the descaler solution into
the tank.
5 Fit the cap and tighten fully.
6 Using the handle, move the steam
cleaner about to swill the solution around
the tank.
7 Leave for 30 minutes.
8 Empty the solution carefully.
9 Rinse the tank with clean warm water,
then empty.
10 Wipe the outside of the cleaner with a
damp cloth to remove all traces of
descaler solution.
WARNING: Do not switch on the
heater with the descaling solution inside.
10
70530 Rev 4 2/6/04 2:53 PM Page 10