Filter
Top Products
• Always disconnect the cleaner from the
mains when checking or replacing the
filters.
• Always make sure the filters are fitted
correctly before use. Failure to do so may
result in damage to your product.
Pre Motor filter
The pre-motor filter Ú can be found by
opening the dust compartment › using the
dust compartment release button fl
Remove pleated hepa filter Ô and mesh
filter. Remove the pre-motor foam filter Ú
from its securing tabs and clean or replace.
Replace the foam filter Ú over the small
tabs making sure it’s located correctly N
Exhaust filter O
The exhaust-filter Û must be cleaned
regularly to remove the fine dust particles
collected. This can be done by shaking it.
The exhaust filter is located behind the
exhaust filter covers fi. To remove, push
down on the tab and remove the cover.
Pull out the foam filter Û and clean or
replace
Using the blower
function
1 Remove the exhaust filter cover fi and
foam exhaust filter Û
2 Push and twist clockwise P the blower
connector Ê into the back of the cleaner
to lock into place.
3 Attach the hose · to the correct end of
the blower connector Ê.
4 The blower function can be used for a
variety of uses including blowing dust
from delicate surfaces and also drying pet
fur.
If using to dry pet fur:
• Never use the product in a wet
environment.
• Do not use if the animal is frightened or
distressed.
• Never leave the product alone with the
animal. Never allow the animal to chew
the product.
7
N
O
P
Hand held vac rev 3 73106/07 4/11/05 1:32 PM Page 7