Filter
Top Products
55
wwwwww..mmoorrpphhyyrriicchhaarrddss..ccoomm
Using on carpets
1 Place the cleaner in it’s upright
position.
2 Set the carpet height
adjustment dial · to the
desired position.
3 Release the mains cable by
revolving the quick release cleat
half-a-turn and extend the cable
fully.
4 Plug the cable into the mains
socket.
5 Step on the handle release
pedal to release the handle to
the desired position.
6 Press the ON/OFF button to the
‘ON’ position.
IMPORTANT: To prevent damage
to carpets:
• Never leave the cleaner
switched on in one place for an
extended period.
• Never have the brushes set too
low such that the cleaner is hard
to push.
• Never lean on the product.
Using the
attachments
Follow steps 1-4 of the ‘Using
on carpets’ section, but set the
carpet height adjustment dial to
the tools setting.
5 Attach the accessories ‚ „ ‰
to the handle, removing the
handle from the telescopic tube,
then firmly push in the desired
accessory F:
Turbo tool ‚ is ideal for pet
hair removal from stairs and
upholstery.
Upholstery tool „ for
upholstery, stairs etc.
Dusting brush „ for delicate
surfaces.
Crevice tool ‰ for awkward
places, corners and behind
radiators etc.
6 If additional length is required,
remove the telescopic tube from
the cleaner, connect it to the
handle, and add the desired
accessory to the end of the tube
G.
7 Switch ON/OFF.
• IMPORTANT: When using the
hose and tools, locate the hose
into the hose hook Ï on the
main unit. This will help prevent
the cleaner from tipping over.
• IMPORTANT: Turning the cleaner
sideways helps prevent the
cleaner being pulled along by
the stretched hose.
Using & cleaning the
turbo nozzle
Attach the Turbo nozzle to either
the handle or the telescopic
tube as described previously.
Following use, your turbo nozzle
may become clogged. Switch
the cleaner to ‘OFF’. Turn over
the tool and pull away any hairs
or fibres. If they are tightly
wound around the brush,
carefully snip the fibres with
scissors, being careful not to
damage the brush bar, pull away
from the brush bar and dispose.
SAFETY CUT-OUT
If the cleaner overheats, a motor
protection thermostat will
automatically switch the motor
off. If this happens, switch the
cleaner off, unplug from the
power supply and leave the
cleaner to cool for at least
60 minutes. Check the airways
for blockages, empty the dust
canister and clean the filters
before restarting.
F
G
73281 rev1 13/3/08 16:22 Page 5