Filter
Top Products
Raise fan with downrod assembled to
the ceiling br
ack
et and hang fan
assembly
. Be sure to rotate the
downrod ball so that the notch in the
bracket engages the slot in the ball.
Install outer upper glass to fan body.
11
17
Install 4 x 25 watt candelabra base
bulbs.
10
Install downrod into yoke. Align hole
in downrod with hole in yoke and
i
nstall cross pin. Install keeper into
cross pin.
8
Tighten 2 downrod set screws and
lock nuts.
9
Set dip switches on the Remote Transmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly
. If y
ou ha
v
e other fans you
can set to control from one tr
ansmitter b
y setting both
receivers the same as the transmitter. If you have more
than one fan with remote. You can set the dip switches to
different positiosns to ha
v
e seper
ate control.
Remote Transmitter Dip swtiches
R
emote R
eceiver Dip switches
16
Fan and light kit combinations over 35 lbs,
in both flush and downrod mode the safety
cable must be installed into the house struc-
ture beams using the 3” lag screws,w
ashers,
and lock washers. provided. Make sure that
when the safety cable is fully extended the
lead wires are longer than the cable and no
stress is placed on the lead wires.
18
Safet
y cable installation
Safety Cable
Lag Screw
safety
cable
3” lag
screw
lock
washer
washer
Install inner upper glass to fan body.
12
Install canop
y onto downrod.
13
Install half ball on downrod and slide
pin into hole in downrod. Then raise
half ball so that pin fits in notches in
half ball.
14
Tighen set screw in half ball.
15
Thread lead wires and safety cable
t
hrough downrod as shown.
7