Filter
Top Products
i
nstall cotter pin into cross pin.
I
nstall downrod into yoke.
Raise fan with downrod assembled to the ceil-
ing bracket and hang fan assembly. Be sure to
rotate the downrod ball so that the notch in the
bracket engages the slot in the ball.
9
12
7
F
or Canadian installation in both flush and
downrod mode the safety cable must be
installed into the house structure beams using
the 3” lag screws provided. Make sure that
when the safety cable is fully extended the
leadwires are longer than the cable and no
stress is placed on the leadwires.
13
Canadian mounting only
Safety Cable
Lag Screw
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet bo
x.
15
Attach blade brackets to blades using the blade
br
ack
et screws and w
ashers pro
vided.
17
R
emove the shipping stabilizer plate and throw
away (see insert). The screws, washers and
motor pads are pre-installed to the blade hold-
ers. A
ttach blade assembly to motor and tight-
en screws securely.
18
S
et dip switches on the Remote Transmitter and Remote
R
eceiver to the same settings. This must be done so the
u
nits will communcate properly. If yo
u have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter. If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
11
Lift Canop
y to ceiling aligning the k
ey
hole slots with the screws on the bottom
of the Mounting bracket. Rotate the
canop
y Counter Clockwise to lock in
place. Tighten the screws to secure the
Canopy. See inset for Keyhole shape
16
A
lign hole in downrod with hole in yoke and
install cross pin.
8
Tighten 2 downrod set screws and lock nuts.
10
Mak
e wire connections as per abo
v
e diagram.
Connect the white wire from the fan to the
White or Neutral wire from the power source.
Connect the black wire from the fan to the
Black or hot wire from the power source.
Connect all Green / Yellow wires from the fan,
Downrod and mounting bracket to the Ground
wire from the house.
14