Filter
Top Products
Tighten 2 downrod set screws.
install cotter pin into cross pin.
Install downrod into yoke.
Thread electrical wires and safety
cable through downrod.
Align hole in downrod with hole in
yoke and install cross pin.
Raise fan with downrod assembled to the ceil-
ing bracket and hang fan assembly. Be sure to
rotate the downrod ball so that the notch in the
bracket engages the slot in the ball.
9
7
10
11
12
8
Set dip switches on the R
emote T
r
ansmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly. If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter. If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
14
Install remote receiv
er by sliding into opening in
the Mounting bracket. Make sure that the dip
switches on the T
r
ansmitter and the R
eceiv
er
are set to the same position. See Fig 26 for
remote operation. The fuse is inside the canopy
mounting.
15
white
R
ed
Make wiring connections as indicated above.
White from fan to white from remote mark
ed
N. Orange from fan to Orange from remote
mark
ed Light/up
. Blue from fan to blue from
remote mark
ed down light. Black from fan to
Red from remote marked L. White from
house to white from remote marked AC N .
Black from house to Black from remote
mark
ed AC L. Connect all green ground wires
to Ground wire from House.
or
ange
blue
Green
white
black
House
Fan
16
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
17
Lift Canop
y to ceiling aligning the key hole slots
with the screws on the bottom of the Mounting
bracket. Rotate the canopy Counter Clockwise
to lock in place. Tighten the screws to secure
the Canopy. See inset for Keyhole shape
18
For Canadian installation and for USA fan and
light kit combinations ov
er 35 lbs, in both flush
and downrod mode the safety cable must be
installed into the house structure beams using
the 3” lag screws,washers, and lock w
ashers.
provided. Make sure that when the safety cable
is fully extended the leadwires are longer than
the cable and no stress is placed on the lead-
wires.
13
Safety cable installation
Safety Cable
Lag Screw
safet
y
cable
3” lag
screw
lock
w
asher
washer