Filter
Top Products
Make wire connections as per above diagram.
Connect the white wire from the fan to the
White or Neutral wire from the power source.
Connect the black wire from the fan to the
Black or hot wire from the power source.
Connect all Green / Yellow wires from the fan,
Downrod and mounting bracket to the Ground
wire from the house.
26
For Canadian installation in both flush and
downrod mode the safety cable must be
installed into the house structure beams using
the 3” lag screws provided. Make sure that
when the safety cable is fully extended the
leadwires are longer than the cable and no
stress is placed on the leadwires.
24
Canadian mounting only
S
afety Cable
Lag Screw
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet bo
x and ungrounded conductor on
the other side of the outlet box.
25
House
Fan
Black
White
Green
Black
White
Green(downrod)
Green(Bracket)
Install 6x15 Watt candelabra bulbs included.
22
Hang assembled fan from the mounting bracket
installed to ceiling in previous step. Make sure
the fan is hanging straight. Rotate fan until the
tab on the Mounting bracket engages the slot
on the Downrod Ball. This must be done to
prevent the fan body from rotating when the
blades are in motion.
23
Re-install safety bar removed in step. 3 by
placing safety bar on screws, sliding into place,
and tightening the 2 screws.
27
Tread leadwires and safety cable through the
d
ownrod.
P
lace downrod into the yoke, align the holes in
the yoke with the holes in the downrod and
i
nstall cross pin. Install keeper pin into cross
p
in.
19
20
T
ighten set screws to hold downrod securely in
t
he yoke. Drop cover over yoke.
21
Place floating brackets onto blades aligning
holes in blade with the floating br
ack
et.
Place blade arms onto the other side of the
blade and aligning holes. Insert screws with
fabric washers though the holes and tighten
securely
.
Remove motor screws from fan motor and save.
28
29
30