Filter
Top Products
32 86D0024
/ CLEANING and SERVICING
CLEANING AND SERVICING
Refer to parts diagram for location of items discussed
• Do not use cleaning uid to clean logs or any part of heater.
• Brush logs with soft bristle brush or vacuum with brush attachment.
• Vacuum loose particles and dust from the front and rear burner, control and piezo
covers and grate weldment.
• Inspect and clean burner air intake holes. Remove lint or particles with vacuum,
brush, or pipe cleaners.
Failure to keep air intake holes clean will result in sooting and poor combus-
• External case should be dusted and wiped with a wet soapy cloth.
Refer to parts diagram for location of items
• Inspect and clean burner air intake holes. Remove lint or particles with vacuum,
brush or pipe cleaners.
Failure to keep air intake holes clean will result in sooting and poor combus-
• Inspect and clean all burner ports.
• Inspect ODS pilot for operation and accumulation of lint at air intake holes.
• Verify ame pattern and log placement for proper operation.
• Verify smooth and responsive ignition of main burner and rear burner.
• Replace battery in remote control device.
Turn off heater and allow to cool before
WARNING
Remove logs, handling carefully by holding gently at each end. Gloves are recommended
to prevent skin irritation from ceramic bers. If skin becomes irritated, wash gently with
soap and water. Refer to manual for correct log placement.
MATCH LIGHTING INSTRUCTIONS
1. Remove any items necessary for easy access to the pilot (for example: logs, screens,
etc.).
2. Follow appropriate lighting instructions found previously. Instead of pushing and releasing the
piezo button, light a match and hold the ame to the end of the pilot and ignite the pilot.
3. After control knob has been released and pilot stays lit, reinstall any items that were removed
for pilot access.
4. Call a qualied service technician for repair or replacement of the piezo ignitor.