Filter
Top Products
26D4721 11
K
J
FIREBOX FRAMING
1. Bend out the nailing flanges located on each side of the firebox.
2. Slide the firebox into prepared framing or position firebox in its final position and frame later.
3. Level the firebox by checking the top edge of the firebox. Shim if necessary.
4. Anchor firebox to the side framing members using 8d nails or other suitable fasteners. See Figure 14.
5. The canopy must be installed for safe operation of the heater. See page 13 for canopy installation details.
When finishing a custom cabinet, mantel, or other built-in enclosure, the open-
ing size to accommodate the fireplace with trim installed is as follows:
Figure 13 - Custom Cabinet
Figure 14 - Location of Nailing Flanges
Nail Sides
Through Nailing
Flanges
The fi replace must be installed giving
full consideration to the clearance and
height requirements identifi ed in this
manual.
WARNING
This appliance is approved for the installation of drywall or other combustible
materials against the sides or top of the black-painted firebox face.
Noncombustible facings will not burn when exposed to heat coming off this
fireplace. The classification, “Noncombustible material” includes brick and
mortar, stone or marble. These are safe to overlay the black-painted metal face
and do not pose a fire hazard. Never overlap the firelace opening.
LCUF32-F with trim LCUF36C-R with trim
K 37¾" 41¾"
J 35⅜" 38⅞"