Filter
Top Products
16 46D0550
46D0550 17
DO NOT sprinkle volcanic rocks on the
logs or around the pilot. This may cause
sooting.
During initial operation of the new heater,
burning logs will give off a paper burning
smell and orange flames will be present.
Simply open the windows for a few hours
to vent the odor.
Log #4
Log #2
Log
#1
Log
#3
Back
Pins
Front
Pins
LOG PLACEMENT
INSTALLING LOGS ON GRATE (See Figure 12)
1. Install back log (#1) on two pins located near the back of base.
Check log position and stability.
2. Install center log (#2) on two pins located near the front of the
base. Make sure the bottom of the log around the pin holes
fully contacts the engine base.
3. Install front log (#3) in front of center log. Make sure bottom
of log is resting on the grate. Do not rest log on burner.
4. Place back end of top center log (#4) on recessed area of back
log (#1) and rest on pin on center log (#2).
Figure 12 - Installing
Logs to Grate
Before you begin — This unit is supplied with four ceramic ber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from ceramic bers. After handling the logs, wash your hands gently with
soap and water to remove any traces of bers.
The positioning of the logs are critical to the safe and clean operation of this heater.
Sooting and other problems may result if the logs are not properly and firmly positioned
in the appliance. Never add additional logs or embellishments such as pine cones,
vermiculite or rock wool to the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts
specifically approved for this heater may result in property damage or personal
injury.
WARNING
CAUTION