Filter
Top Products
38 71D0532
TRIM INSTALLATION
1. Remove top and bottom louver assemblies by disengaging hooks. Pull assemblies up and away from unit.
See Figure 33.
2. Remove canopy by removing screws and pulling canopy away from unit. See Figure 34.
3. Set bottom trim kit piece in place on bottom of face. Bottom piece will be held in place by the side pieces.
See Figure 34.
Figure 33 Figure 34
4. Loosely install four supplied screws
into left and right sides of unit face.
Leave approximately 1/8th in. of
screw shaft protruding from unit
in each location. See Figure 35.
5. Set left and right side piece of trim
kit in place on unit. Lean the top of
each piece away from the unit and
towards you in order to install top
trim kit piece. Top piece should
fi t with sides as shown.
See Figures 36, 37 & 38
Figure 35