26
58D6056
CSDV Series Direct Vent Gas Stove
— This unit is supplied with ceramic fiber logs. Do not handle these logs
with your bare hands.
After handling the logs, wash your hands gently with soap and water to remove any traces of
fibers.
Figure 36
1. Carefully remove logs from wrapping.
2. Open front door of firebox.
3. Place rear log (#1) on rear log pin.
4. Place left base log (#2) on the two pins against left
side of firebox.
5. Place right base log (#3) on the two pins against right
side of firebox.
PILOT
OFF
REMOTE CONTROL
LG813
CSDV20 logs
Left Base
Log #2
Right Base
Log #3
Rear Log
#1
Pins
Pins
LG813
Figure 36 -
Place CSDV20 Logs
on Base
Break up rock wool (ember material) into dime-sized
pieces. Fluff up rock wool. Place rock wool evenly across
burner surface. Do not block any areas around the perim-
eter of the burner, as these are the areas that supply the
needed air for secondary combustion.
Figure 37
PILOT
OFF
REMOTE CONTROL
LG814
CSDV20 rockwool
Rock Wool
LG814
Figure 37 -
CSDV20 Rock Wool Placement