Filter
Top Products
4
1
2
3
■ Wireless Remote-Controller (option)
2. Parts Names
■ When using the wireless remote controller, point it towards the receiver on the indoor unit.
■ If the remote controller is operated within approximately two minutes after power is supplied
to the indoor unit, the indoor unit may beep twice as the unit is performing the initial auto-
matic check.
■ The indoor unit beeps to confirm that the signal transmitted from the remote controller has
been received. Signals can be received up to approximately 7 meters in a direct line from
the indoor unit in an area 45° to the left and right of the unit. However, illumination such as
fluorescent lights and strong light can affect the ability of the indoor unit to receive signals.
■ If the operation lamp near the receiver on the indoor unit is flashing, the unit needs to be
inspected. Consult your dealer for service.
■ Handle the remote controller carefully! Do not drop the remote controller or subject it to
strong shocks. In addition, do not get the remote controller wet or leave it in a location with
high humidity.
■ To avoid misplacing the remote controller, install the holder included with the remote con-
troller on a wall and be sure to always place the remote controller in the holder after use.
Battery installation/replacement
1. Remove the top cover, insert two AAA batter-
ies, and then install the top cover.
Top cover
2. Press the Reset button.
CLOCK
CHECK
RESET
SET
TEST RUN
MODE
FAN
VANE
LOUVER
min
h
AUTO START
AUTO STOP
ON/OFF
TEMP
NOT AVAILABLE
MODEL SELECT
TEST RUN
CHECK
ON/OFF button
Pushing button starts operation.
Pushing again stops operation.
MODE SELECT button
This button is used to change be-
tween auto, cooling, heating and
drying operation modes.
SET TEMPERATURE button
SET TEMPERATURE button sets
and any desired room tempera-
ture.
AUTO STOP/AUTO START button
Used for selecting timed starting
or stopping.
h button
Used for setting the current time.
VANE CONTROL button
Used to change the airflow direc-
tion.
Two AAA batteries
Insert the negative (–)
end of each battery
first. Install the batter-
ies in the correct direc-
tions (+, –)!
FAN SPEED button
This button is used to set fan
speed to low, medium or high.
CHECK button
TEST RUN button
min button
Used for setting the current time.
LOUVER button
Used for adjusting the airflow di-
rection.
Press the Reset button
with an object that has
a narrow end.
KB79P513H01_EN.pm65 6/25/09, 4:59 PM4