Filter
Top Products
– 15 –
Airfl ow direction adjustment
■ Up/down direction can be adjusted with the AIRFLOW U/D (UP/DOWN) button on the remote control. Every time you press this button
the mode changes as follows:
Change on AIRFLOW (UP/DOWN) mode.
■ Left/right direction can be adjusted with the AIRFLOW L/R (LEFT/RIGHT) button on the remote control. Every time you press this
button the mode changes as follows:
Change on AIRFLOW (LEFT/RIGHT) mode.
MEMORY FLAP (FLAP OR LOUVER STOPPED)
When you press the AIRFLOW (U/D or L/R) button once while the fl ap or louver is operating, it
stops swinging at the position. Since this angle is memorized in the microcomputer, the fl ap or
louver will automatically be set at this angle when the next operation is started.
WARNING
• Do not expose directly to airfl ow from the air-conditioner for a long time.
CAUTION
• When in COOL or DRY operation, do not operate for a long period with the
airfl ow blowing straight down. Otherwise, condensation may appear on the
outlet grill and drip down.
• Do not try to adjust the fl aps and louvers by hand, as the control angle may
change or the fl ap or louver may not be closed completely.
HEAT
(Horizontal
blowing)
(Slant forward
blowing)
COOL, DRY
• Recommended angle of the flap when
stopping
• When operation starts, the fl ap and louver direction is fi xed at the horizontal / center position in order to avoid cold draft, and return
to the set the position that was set after the warm air supply is starting.
• The fl ap and louver direction will be controlled to the horizontal/center position when the room temperature reaches the set
temperature and compressor stops or when defrosting is in operation.
• The airfl ow direction cannot be set during the period mentioned above. Change the airfl ow direction settings after the warm air is
supplied and the fl ap/louver goes to the set position.
(Swing)
(Flap stopped)
(Louver stopped)
(Swing)
NOTE FOR HEATING OPERATION
• The actual position of the fl ap and louver may differ from the display shown.
NOTE
3D AUTO operation
■ Fan speed and air fl ow direction are automatically controlled, allowing the entire room to be effi ciently conditioned.
Press the ON/OFF button.
Press the 3D AUTO button.
Each time the 3D AUTO button is pressed, the display is switched in the
order of:
1
2
(Normal operation)(3D AUTO)
No display
• 3D AUTO operation is canceled when you switch the operation mode.
• If 3D AUTO operation is cancelled then the air fl ow direction changes to
that used before 3D AUTO was set.
• 3D AUTO operation can be set in AUTO, COOL, or HEAT operation mode
only.
NOTE
Releasing procedure
Press the 3D AUTO button to turn off the 3D AUTO display.
RLD012A002G_EN.indd 15RLD012A002G_EN.indd 15 2015/02/27 14:36:412015/02/27 14:36:41