Mitsubishi Electronics SKM25ZD-S Air Conditioner User Manual


 
–9–
1
2
COOL/HEAT/DRY mode operation procedure
Air flow direction adjustment procedure. Page 10
Program changing procedure
Set the new program.
The operation program can also be set or changed when
the air conditioner is not in operation.
HI POWER
TEMP
ECONO
AIR FLOW
CANCEL
ON OFF
RESERVE
TIMER
TIME
ACL
FAN SPEED
ON
MODE
LO
MED
HI
AUTO
TIME
OFF
HI POWER
ECONO
AM
Aim the remote control at the air conditioner.
Press the ON/OFF button.
Press the MODE select button.
Move the [ mark] to the desirable operation position.
(Cool), (Heat), (Dry)
Press the TEMP button.
Press or button for the desired temperature.
Standard
Press the FAN SPEED button
Set the air flow rate as desired.
4
3
COOL
DRY
FAN
HEAT
26°C~28°C21°C~24°C22°C~24°C
To stop: Press the ON/OFF button.
NOTE
Concerning high power operation
Pressing the high power button intensifies the operating power and initiates a powerful cooling or heating operation for 15 minutes continuously.
The remote controller illuminates but the wind capacity display is erased.
Concerning economy operation
Pressing the economy button initiates a soft operation with the power suppressed in order to avoid an excessive cooling or heating. The unit operates
1.5°C higher than the setting temperature for the weak wind capacity during cooling or 2.5°C lower than that during heating. A message is
displayed on the remote controller. The wind capacity display is erased.
NOTE
NOTE
During the high power operation, the room temperature is not con-
trolled. When it causes an excessive cooling or heating, press the
high power button once more to cancel the high power operation.
High power operation is not available during the dehumidifying
operation.
During ON timer operation, HI POWER operation will start when
the ON time is reached.
If the economy operation is selected while operating with the
strong or medium wind capacity, it takes about 1 minute before the
wind capacity drops to the weak level.
HI POWER
ECONO
When the following operations are conducted HI POWER opera-
tion will be canceled.
1 When the HI POWER button is pressed again.
2 When the operation mode is changed.
3 When ECONOMY operation is conducted.
When the following operations are conducted ECONOMY opera-
tion will be canceled.
1 When the ECONOMY button is pressed again.
2 When HI POWER operation is selected.
Air is not blown out during the operation.
Page 18
The air-conditioners cannot be in different
operating modes at the same time, such as
one unit being in the “Cool” mode and one
unit being in the “Heat” mode.
RWA012A226_En 03.8.27, 6:46 PM9