Filter
Top Products
41
<How to operate>
To change the air flow direction, press AIR DISCHARGE UP/DOWN button.
1
10°
2
30°
3
60°
4
70°
(1) COOL/DRY operation
At the start-up of COOL or DRY operation, the discharge direction in automatically set to 10°. After, it can be changed to
another direction with AIR DISCHARGE UP/DOWN button on the remote controller.
<Auto return>
When 60° or 70° discharge is set with fan speed on LOW, “AUTO RETURN” appears below the room temperature display.
One hour later the direction changes to 10° degrees, automatically and “AUTO RETURN” disappears.
(2) HEAT operation
At the start-up of HEAT operation, discharge direction depends on the setting of the last operation.
After, it can be changed to another direction with AIR DISCHARGE UP/DOWN button. The discharge direction shifts to 10°
regardless of the remote controller settings under any of the following conditions.
● Thermostat OFF
● Defrosting
● Indoor fan speed EXTRA-LOW in hot adjustment
Available in COOL operation with fan speed on HIGH or
in HEAT operation.
Unavailable in DRY operation.
If fan speed changes from LOW to HIGH during 30°
downward discharge in COOL mode, the direction auto-
matically changes to 10°.
discharge
1
downward discharge
2
downward discharge
3
downward discharge
4
2-5 Auto vane control
<Remote controller display>
MITSUBISHI ELECTRIC
-CENTRALLY CONTROLLED-
STAND BY
DEFROST
ON
CHECK DRY
COOL
HEAT
CHECK
SET TEMP
TIMER OFF
AUTO STOP
AUTO START
F
HR
F
LOW HIGH
AUTO RETURN
CHECK TEST RUN
POWER
ON/OFF
HEAT
SET
TEMPERATURE
AUTO COOL/DRY
COOLERWARMER
TIMER MODE HOURS
FAN SPEED LOW/HIOGH
AIR
DISCHARGE
UP/DOWN
SWING
STOP
CHECK TEST RUN
Changes by pressing
the AIR DISCHARGE
UP/DOWN button.
OC120--2.qxp 24/6/97 12:32 AM Page 41