Filter
Top Products
39
OPERATING PROCEDURE PHOTOS
1. Removing the cabinet
(1) Remove the screws of the service panel.
(2) Remove the screws of the top panel.
(3) Remove the screw of the valve cover.
(4) Remove the service panel.
(5) Remove the top panel.
(6) Remove the valve cover.
(7) Remove the screws of the cabinet.
(8) Remove the cabinet.
(9) Remove the screws of the back panel.
(10)
Remove the back panel.
39
(1) Slide the sleeve and check if there is a locking lever or not.
(2) The terminal with this connector has the
locking mechanism.
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Hold the sleeve, and
pull out the terminal
slowly.
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
<"Terminal with locking mechanism" Detaching points>
Connector
Sleeve
Locking lever
MUZ-D30NA MUZ-D36NA MUY-D30NA MUY-D36NA
Photo 2
Photo 1
Photo 3
11
DISASSEMBLY INSTRUCTIONS
Screws
of the
cabinet
Screws of the cabinet
Screw of
the top
panel
Screws of the
top panel
Screws
of the
cabinet
Screw of the service panel
Screw of the
valve cover
Set screws of
the back panel
Screw of the motor support
Screws of
the back
panel
Conduit plate
Set screws of the back panel