9
ON/OFF
FAN
TOO
WARM
TOO
COOL
VANE
MODE
STOP
START
HR.
MIN.
I FEEL
COOL
DRY
AMPM
CLOCK
˚C
AMPM
HEAT
RESET CLOCK
AIR FLOW VELOCITY AND DIRECTION ADJUSTMENT
AIR FLOW velocity and direction can be selected
as required.
Auto air flow direction control operation
■ When the AUTO mode is selected with the
VANE
button, the position of the horizontal vane is automatically set
to correspond to the operation mode for effective operation.
(1) HEAT
When the air flow temperature is too low, When the air flow temperature rises,
the air is blown out horizontally. the air is blown out downwards.
(2) COOL, DRY
The air is blown out horizontally.
■
To change the horizontal direction of the air flow, move the vertical vane manu-
ally.
Adjust the vane before operation starts.
Since the horizontal vane moves automatically, your fingers may be caught.
■
To change the AIR FLOW velocity, press
the
FAN
button.
Each time the button is pressed, the fan speed is
changed in sequence: (Low) → (Med.) → (High)
→
(AUTO)
•
Use the (High) notch to cool/heat the room more.
•
If the operating sound of the air conditioner disturbs your
sleep, use the
(Low) notch.
■
To change the AIR FLOW blowing direc-
tion vertically, press the
VANE
button.
Each time the button is pressed, the angle of the hori-
zontal vane is changed in sequence:
(1) → (2) →
(3) → (4) → (5) → (SWING) → (AUTO)
SWING OPERATION
Use the swing operation for the air flow to reach all cor-
ners of the room.
Recommended horizontal
vane range
Use the (AUTO) position usu-
ally.
Use position
(1) or (2) in the
COOL or DRY mode and use posi-
tions
(3) to (5) in the HEAT mode
when adjusting to your require-
ments.
NOTE
■ In the cooling operation, when the air conditioner is op-
erated with setting the horizontal vane to
(4) or
(5) for
1 hour, the AIR FLOW direction is automatically set to
horizontal to prevent condensed water from dropping.
■ Adjust the vertical AIR FLOW direction using the remote
controller. If the horizontal vane is moved manually, it
may cause trouble.
■ In the heating operation, if the air flow temperature is
too low or when defrosting is being done, the horizontal
vane position is set to
(1).
COOL
DRY
HEAT
1
2
3
4
5