Filter
Top Products
En-3
• OPERATING INSTRUCTIONS •
Temperature buttons
Page 4
Off-timer button Page 6
On-timer button Page 6
TIME set buttons Pages 3, 6
Increase time
Decrease time
CLOCK button Page 3
RESET button Page 3
Lid
Slide down to open
WIDE VANE button
Page 5
T
E
S
ER
KC
O
L
C
• Make sure the polarity of the batteries is correct.
•
Do not use manganese batteries. The remote controller could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin stick.
If the RESET button is not pressed, the remote controller may not operate correctly.
• Press CLOCK gently using a thin stick.
RES
ET
Display section
Operation indicator
lamp
Remote control
receiving section
Emergency
operation
switch
Page 4
Air inlet (back and side)
Piping
Drainage hose
Air outlet
Drain outlet
Remote controller
holder
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit when
the signal is received.
Operation display
section
ON/OFF
(operate/stop)
button
Operation
select button
Page 4
ECONO
COOL
button
Page 6
FAN speed
control button
Page 5
VANE
control button
Page 5
• Install the remote control-
ler holder to a place where
the signal can be received
by the indoor unit.
Use the remote controller provided with the unit only.
Do not use other remote controllers.
Horizontal vane
Vertical vane
Air outlet
Air fi lter
(Catechin air fi lter)
Air inlet
Front panel
Air cleaning fi lter
(Anti-Allergy Enzyme Filter)
Outdoor unit
NAME OF EACH PART
PREPARATION BEFORE OPERATION
1.
Remove the front lid
2.
Insert AAA
alkaline batteries
3.
Install the front lid
1.
Press CLOCK
3.
Press CLOCK again
2.
Press the TIME buttons to set the
time
Each press increases/decreases
the time by 1 minute (10 minutes
when pressed longer)
Indoor unit Remote controller
Appearance of the outdoor unit may differ from some models.
LONG
button
Page 6
4.
Press RESET
Installing the remote controller batteries Setting current time
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.