Filter
Top Products
9
ON/OFF
FAN
TOO
WARM
TOO
COOL
VANE
MODE
ECONO COOL
STOP
START
HR.
MIN.
I FEEL
COOL
FAN DRY
AMPM
CLOCK
˚C
AMPM
RESET CLOCK
TIMER OPERATION (ON/OFF TIMER)
It is convenient to set the timer for the time when
you go to bed, when you get home, when you get
up, etc.
TIMER
How to set the ON timer
1 Press the
START
button during operation.
Each time the button is pressed, the ON timer mode
alternates between ON and OFF.
2 Set the time of the timer using the
HR.
and
MIN.
buttons.
Each time the
HR.
button is pressed, the set time is
counted up by 1 hour; each time the
MIN.
button is
pressed, the set time is counted up by 10 minutes.
To release the ON timer:
■
Press the
START
button.
How to set the OFF timer
1 Press the
STOP
button during operation.
Each time the button is pressed, the OFF timer mode
alternates between ON and OFF.
2 Set the time of the timer using the
HR.
and
MIN.
buttons.
Each time the
HR.
button is pressed, the set time is
counted up by 1 hour; each time the
MIN.
button is
pressed, the set time is counted up by 10 minutes.
To release the OFF timer:
■
Press the
STOP
button.
Programming timer operation
The ON timer and the OFF timer can be used in com-
bination. The timer of the set time that is reached first
will operate first. (“
” mark indicates the order of timer
operations.)
• If the current time has not been set, the timer op-
eration cannot be used.
WHEN THE AIR CONDITIONER IS NOT GOING TO BE
USED FOR A LONG TIME
When it is not going to be used for a long
time:
1 Perform FAN operation for 3 or 4 hours to
dry the inside of the air conditioner.
2 Turn off the breaker.
Caution:
Turn off the breaker when the air conditioner is not go-
ing to be used for a long time.
Dirt may collect and this may cause a fire.
3 Remove the batteries from the remote con-
troller.
Caution:
To prevent liquid leakage, take out all batteries when the
remote controller is not going to be used for a long time.
MAINTENANCE
Before starting maintenance
■
Turn off the breaker.
Caution:
When the unit is to be cleaned, switch it off and turn off
the breaker.
Since the fan rotates at high speed during operation, it
may cause an injury.
Cleaning the indoor unit
■
Clean the unit using a soft dry cloth.
Do not use gasoline, benzine, polishing powder, deter-
gent and insecticide. The unit may be damaged.
When the air conditioner is to be used
again:
1 Clean the air filter and install it in the indoor
unit.
(Refer to page 10 for cleaning instructions.)
2 Check that the air inlet and outlet of the in-
door/outdoor unit are not blocked.
3 Check that the earth is connected correctly.
Caution:
Earth the unit.
Do not connect the earth to a gas pipe, water pipe, light-
ning rod or the earth of a telephone. If the earthing is
incorrect, it may cause an electric shock.
Clean the filter
before installing.
FAN operation