Filter
Top Products
7
ON/OFF
FAN
TOO
WARM
TOO
COOL
VANE
MODE
ECONO COOL
STOP
START
HR.
MIN.
I FEEL
COOL
FAN DRY
AMPM
CLOCK
˚C
AMPM
RESET CLOCK
MANUAL OPERATION (COOL, DRY, FAN)
To select the “COOL”, “DRY” or “FAN” mode:
1 Press the
ON/OFF
button.
2 Select the operation mode by pressing the
MODE
button.
Each time this button is pressed, the operation mode
is changed in sequence :
(I FEEL...) → (COOL)
→
(DRY) → (FAN)
To stop operation:
■
Press the
ON/OFF
button.
After the operation mode is set once, the operation
starts in the same mode as the one set previously from
the next time by simply pressing the
ON/OFF
button.
■
When the set temperature is to be
changed:
• Press the
TOO
WARM
button to lower the tempera-
ture.
One press lowers the temperature by about 1°C.
• Press the
TOO
COOL
button to raise the tempera-
ture.
One press raises the temperature by about 1°C.
In “DRY” operation
• The temperature control (temperature setting)
cannot be done.
• The room temperature is slightly lowered in
this operation mode.
Note:
When the ambient temperature is too high,
the room temperature may not reach the set
temperature since the unit operates to cool
under high load.
■
The details of the display on the indoor
unit are explained on page 6.
“COOL” For effective cooling
1 Close the windows and pull down
blinds. Sunlight is reduced and
cooling efficiency increases.
2 Paste a heat shield film (generally
available) on the window. Heat en-
tering the room is reduced.
3 Block the outdoor unit from direct
sunlight. This saves energy.
CONVENIENT INFORMATION
“DRY” The humidity at which people feel comfortable
When air contains too much moisture, people feel uncomfortable. Humidity is related to temperature and wind. The humid-
ity at which people feel comfortable is 60%-75% RH. in summer, 55%-70% RH. in winter.