Filter
Top Products
INSTALLATION
PAGE 7
Once the outside air floor duct is in position, replace the
floor protector. Make sure that the floor protector's hole
is aligned with the outside air opening. Next position
and align the stove on the hearth pad. Manufactured
(mobile) home installations require that the stove be
secured to the floor. This ensures that the stove will not
shift when the manufactured (mobile) home is moved.
To do this, mark where the holes are to be drilled using
a marking instrument long enough and small enough to
fit through the (4) four holes in the stove base. Mark
holes, then remove the stove. Drill the (4) four holes,
with a 1/4" (7 mm) drill bit. Drill down through the floor
protector and the manufactured (mobile) home floor.
Use 1/4" (7 mm) lag bolts and secure to the manufac-
tured (mobile) home floor.
NOTE: If the composition of the manufactured (mobile)
home floor is of light particleboard construction, you will
be required to secure the stove with regular hex head
bolts and nuts. This will ensure that the bolts will not rip
out of the floor when the manufactured (mobile) home is
being moved.
Regulations require that all stoves installed in manufac-
tured (mobile) homes must be grounded. To do this
simply attach a piece of No. 8 copper wire, at least 18"
(457 mm) in length from the stove to the chassis of the
manufactured (mobile) home.
Marble is a natural product and therefore each piece
will have its own unique character. Marble can be
scratched so care should be taken to avoid putting
heavy or rough objects (trivet/steamers) on the surface.
If the marble should become scratched, the scratch
may be removed or diminished by polishing it with jew-
elers rouge (which can be purchased at many hardware
stores). Do not install the marble before curing the
paint.
The marble set consists of 2 pieces. A large piece
which fits onto the stove top and a smaller piece which
fits onto the ashlip which is located below the fuel door.
Install the marble gasket and marble as follows:
1. Install gasket on stove top as shown in the illustra-
tion. The ceramic fiber blanket and strips (cerawool)
which come
with each unit
must be placed
under the mar-
ble to insulate it
from the high
temperatures
on top of the
firebox. Do not
place the mar-
ble directly on
the top metal surface of the stove or it will crack.
2. Place top marble piece onto the gasket on stove
top
3. Place ashlip marble into recessed area on the stove
ashlip (located below the fuel door).
SECURING THE STOVE TO THE FLOOR
Manufactured (Mobile) Homes Only
INSTALLING MARBLE ACCENTS
GROUNDING STOVE
Manufactured (Mobile) Homes Only