Filter
Top Products
^
Install the new ActiveAirClean 50 or
HEPA AirClean 50 exhaust filter and
press it downwards.
^
Press the exhaust filter change
indicator ~ (see fig. 12).
^
After about 10-15 seconds, a small
red marker will appear in the left-hand
side of the display (see fig. 13).
If you want to install an Air Clean
exhaust filter, you must adhere to
the section "Maintenance and
care - Exchanging exhaust filters".
^ Close the dust compartment lid until
it clicks into place.
Exchanging exhaust filters
Depending on the model, your vacuum
cleaner will use one of the following
standard exhaust filters (see fig. 9):
a Air Clean Filter
b ActiveAirClean 50 Filter (black)
c HEPA AirClean 50 Filter (white)
Important
1. If you replace exhaust filter a with
exhaust filter b or c, you must be sure
to remove the filter frame before
inserting the new filter type. The
exhaust filter change indicator must
also be activated (see fig. 12).
2. If you replace exhaust filter b or c
with exhaust filter a, you must be sure
to place the new filter in the filter frame
* (see fig. 37).
* Filter frame - see section on "Optional
accessories"
Make sure that only one exhaust
filter is inserted in the frame.
Service indicator with reset button
(see fig. 40)
The indicator light will come on after
approx. 50 hours of operation, which is
equivalent to one year of average use.
Check if the motor protection filter and
the exhaust filters need to be replaced
as well. You will need to reset the
indicator after replacing any of these
components.
To do this, the vacuum cleaner must be
turned on.
^ Press the reset button.
The service indicator will go out and be
reset to its original position.
The reset feature only works properly
if the indicator light has already come
on, but not if the reset button is pres-
sed in between filter changes.
Changing the batteries on the LED
handle (see fig. 15 + 16)
You will need three AAA (1.5V) batteries.
a Loosen the screws on the cover.
b Press down on both sides of the
cover to remove.
c Take out the battery holder and
change the 3 batteries, making sure
they are inserted correctly.
d Replace the battery holder in the
direction of the arrows on the holder
and battery compartment, so that both
line up.
e Replace the cover and tighten the
screws.
en
18