Filter
Top Products
Replacing the "ACTIVE HEPA"
filter
^
Open the dust compartment lid.
Do not use more than one filter at a
time.
^
Lift and remove the filter.
^ Insert a new filter and press it
downwards.
If you wish to replace the SUPER air
clean filter with an ActiveAirClean
filter or Active HEPA filter see
"Maintenance and care -
Exchanging exhaust filters".
^ Close the dust compartment lid firmly
until it clicks into place.
Resetting the filter change indicator
The filter change indicator (Reset
button) must be reset each time the
filter is replaced. To do this, the
vacuum cleaner must be plugged in.
^
Press and hold the filter change
indicator light until it goes out.
The display is now reset.
The indicator is only reset if pressed
while lit. If the indicator is pressed
while not lit, it will not be reset.
Maintenance and care
27