Filter
Top Products
The illustrations referred to in the text
are shown on the fold-out pages at
the end of these operating
instructions.
Preparing for use
Attaching the suction hose (dia. 1)
^
Insert the hose connector into the
socket on the vacuum cleaner until it
clicks into position. To do this, line up
the guides on the two pieces.
Removing the suction hose (dia. 2)
^ Press the release buttons at the side
of the hose connector and lift the
hose from the socket.
Connecting the handle to the suction
hose (dia. 3)
^ Insert the suction hose into the
handle until it clicks into position.
Connecting the handle to the suction
tube (dia. 4)
^
Insert the handle into the suction tube
until it clicks into position. To do this,
line up the guides on the two pieces.
^
To release the handle from the
suction tube, press the release
button and pull the handle away from
the suction tube.
Your vacuum cleaner is fitted with one
of the following telescopic tubes,
depending on the model:
–
Telescopic tube
–
Triscopic tube
Adjusting the telescopic suction tube
(dia. 5)
One part of the telescopic tube is
packed inside the other and can be
adjusted to suit your height for
comfortable vacuum cleaning.
^
Press the release button to release
the tubes and adjust to the required
height.
Adjusting the triscopic suction tube
(dia. 6)
The triscopic tube has three sections.
Two sections are packed together
inside a third outer tube.
a Press the release button to release
the lower tube and pull it right out until
it clicks. Press the button again when
you want to retract the tube. The tube
will click into place.
b Press the release button to release
the tubes and adjust to the required
height.
Fitting the floorhead (dia. 7)
^
Push the suction tube into the
floorhead and turn it clockwise or
anti-clockwise until it clicks into
position.
^
To release the floorhead from the
suction tube, press the release
button and pull the suction tube away
from the floorhead.
en
35