Filter
Top Products
Switching on
^
To ignite the burner press the control
knob down and turn it anti-clockwise
to the large flame symbol. The ignitor
will make a clicking sound and ignite
the gas.
Operating a control will automatically
create a spark on every burner. This
is quite normal and does not indicate
a fault.
If the burner does not ignite, turn the
control to off "ß". Air the room or wait at
least 1 minute before trying again.
If the burner does not ignite the second
time, turn the control to "ß", and see
"Problem solving guide".
When switching on, re-ignition
sometimes occurs (1-2 clicks) if the
flame on the ignition safety device has
gone out briefly, or if the thermal
element is not hot enough, e.g.
following a gust of air.
Regulating the flame
The burners can be regulated at any
level between the strongest and
weakest flame.
Control the flame so that it does not
spread out beyond the sides of the
pan. As the outer part of the flame is
much hotter than the centre, the tips of
the flames should stay beneath the pan
base. Flame tips which extend beyond
the sides of the pan merely warm up
the air in the room and can also
damage pan handles and increase the
danger of injury.
Switching off
^ Turn the control clockwise to position
"ß".
This stops the flow of gas and the flame
goes out.
Operation
23